Home » Our Product » Electronics Engineering Lab Equipments » Digital Design Experimenter

Digital Design Experimenter Manufacturer,Supplier and Exporter in India

Product Code : SCL-EELE-12678

The Digital Design Experimenter is intended for training of digital electronics. The digital design experimenter covers regular digital circuits by solder-less interconnections on breadboard and as well as compatible with all optional modules through use of patch cords. Various clock generators, logic level input/output indicators and DC regulated power supplies etc. are in-built. The unit housed in attractive enclosure is supplied with mains cord, patch cords, Instruction manual and Component Set.

Features:

Logic Indicators: 4 independent buffered logic level indicators for High / Low status indication of digital outputs
Clock: 3 Fixed Clocks of 1Hz, 1KHz, and 100KHz. That can be selected by Switch position and ports are provided for getting normal output CLK and for getting inverted output CLK.
Logic Switch: Switch A-A controls a latching flip-flop made up of sections A and B. Switch B-B operates the same as switch A-A.
Line Source: It generates an AC signal as Square wave of 50Hz.
Data Switch: 4 independent logic level inputs to select High / Low levels.
Power Supply: +5 V at 500 mA, +12 V at 100mA, -12 V at 100 mA, and GND.
Bread Board: Unique solder-less large size, spring loaded breadboard consisting of two Terminal Strips with 1280tie points and 4 Distribution Strips with 100 tie points each, totaling to 1680 tie points. Size:112mm x 170mm approx).

Objects

LED Display.
AND Gate.
OR Gate.
NOT Gate.
NAND Gate.
NOR Gate.
XNOR Gate.
RS Latch.
To Prove DE-Morgan's Theorem with Boolean Logic Equations.
Binary to Gray Code Conversion.
Gray Code to Binary Conversion.
Binary to Excess-3 Code Conversion.
Binary Adder and Subtractor.
Binary Multiplier.
EX-OR Gate Implementation.
Application of EX-OR Gate.
JK Flip Flop (Without Clock).

Technical Specification
Output Voltages	+12 volts DC at 100 mA.
	-12 volts DC at 100 mA.
	+5 volts DC at 500 mA with thermal overload protection.
Load Regulation	+12 volts DC, better than 1%.
	-12 volts DC, better than 1%.
	+5 volts DC, better than 2%.
Data Switches
States	+5 volts or 0 volts.
Maximum Current	10 mA, each switch.
Outputs	4 terminals, one for each switch.
Logic Switches
Type	Momentary contact, spring loaded.
Circuit	Two flip-flop latches for contact bounce buffering.
Output States	Complementary, +5 volts and +0.2 volts.
Clock:	Frequency Selection
3-position slide switch.
Output Frequency	1 Hz, 1 kHz, 100 kHz; ±20%.
Duty Cycle	45%.
Output Voltage	5 volts peak-to-peak.
Output Terminals	Normal and complement.
Logic Indicators	Red light emitting diode (LED).
General:
Power Requirements	105-130 volts or 210-260 volts rms, 50-60 Hz, 15 watts maximum.
Fuse	3/16-ampere, slow-blow.
Dimensions	200 x 300 x 73mm
Net Weight	3kg (Approx)