SMPS trainer Kit (For Colour Television) Manufacturer,Supplier and Exporter in India
Product Code : SCL-EELE-12292
Indian Lab Suppliers supplies the SMPS trainer Kit (For Colour Television) (Product ID: 12292) as part of its electronics engineering lab equipment range. It is a working switched-mode power supply of the kind used in 14 and 20 inch CRT colour televisions, laid out on an enlarged PCB with test points.
Quick Answer
The supply accepts 180-270 V AC, 50 Hz and delivers a 110/115 V ±5% high-voltage rail at up to 550 mA plus 24 V, 18 V and 12 V rails (±2%, 1 A max each), about 90 W ±10 W in total. Students identify each section, measure voltages and waveforms at the test points, and remove components to see how faults show up. A 3½-digit multimeter, 20 MHz CRO, 2 A variac, rheostat up to 24 ohm / 1 A and a 60 W bulb with holder (dummy load for the 110 V DC test) are required. The primary side works at rectified mains voltage and its capacitors stay charged after switch-off, so fault work needs supervision and a fully discharged board.
Key Specifications
| Parameter | Detail |
|---|---|
| Input | 180-270 V AC, 50 Hz |
| High-voltage output | 110/115 V ±5% at 550 mA max |
| Low-voltage outputs | 24 V, 18 V and 12 V, each ±2% at 1 A max |
| Power output | 90 W ±10 W |
| Construction | Enlarged PCB with test points for voltages and waveforms |
| Experiments | Sections of an SMPS, test-point measurements, fault creation and diagnosis |
| Also required (not included) | 3½-digit DMM, 20 MHz CRO, 2 A variac, rheostat up to 24 ohm / 1 A, 60 W bulb with holder |
Where This Is Used
Used in consumer-electronics servicing and power-electronics training. Companion kit: SMPS trainer Kit (For Computer) (Product ID: 12293); see also Switching Mode Power Supply (SMPS) with 2 meters (Product ID: 12220). Browse the full Electronics Engineering Lab Equipment range or related Electronics Lab Equipment products.
Frequently Asked Questions
What input voltage range does it accept?
180-270 V AC at 50 Hz.
What is the 60 W bulb for?
It acts as a dummy load when testing the 110 V DC output.
Can faults be simulated?
Yes, by removing components and observing the effect.
Related Categories
Electronics Engineering Lab Equipment · Electronics Lab Equipment · Engineering Lab Equipment
Request a Quote
For pricing, bulk quantities or tender documentation on the SMPS trainer Kit (For Colour Television), reach our team via Contact Us or submit your requirement through our Tenders page.
.png)
.jpg)
.png)
.jpg)
.jpg)
.png)