Digital Satellite Communication System Manufacturer,Supplier and Exporter in India

Product Code : SCL-EELE-12355

Indian Lab Suppliers supplies the Digital Satellite Communication System (Product ID: 12355) as part of its electronics engineering lab equipment range. It is a two-station digital satellite link trainer that sends live audio and video over a transponder so each block of the chain can be studied.

Quick Answer

A ground-station transmitter takes audio/video as UDP streams from a 10/100 Mbps IP router, adds a CRC to each packet, HDLC-encodes and scrambles the bit stream, applies variable-rate forward error correction and PSK (BPSK or QPSK) baseband modulation, then up-converts to an RF carrier set anywhere from 400 MHz to 3 GHz. The transponder relays the signal and the receiver station down-converts, demodulates and decodes it; detachable directive dish antennas are fitted at each station, and a direct link can be used in place of the satellite path. The I and Q channels use dual 16-bit, 500 MSa/s DACs with ±13 MHz analog low-pass filters. An internal test-data mode supports bit-error-rate measurement; the carrier-to-noise experiment needs a spectrum analyser, which should be confirmed at quotation.

Key Specifications

ParameterDetail
RF band400 MHz to 3 GHz, user-configurable (transmitter, transponder, receiver)
Network interfaceIP router 10/100 Mbps; UDP streaming; Ethernet port for PC
CodingCRC per IP packet; HDLC encoding and scrambling; variable-rate FEC
ModulationPSK (BPSK, QPSK), I and Q channels
DACsDual 16-bit, 500 MSa/s
Analog LPF±13 MHz (3 dB)
RFBuilt-in up and down converters, low-noise frequency synthesiser
AntennasDetachable directive dish at each station
Test modesInternal test-data mode for BER; direct or satellite link

Where This Is Used

Used in satellite and digital communication labs to run end-to-end audio and video links, BPSK/QPSK modulation, I-Q constellation and BER experiments. Antenna work continues on the Motorised Antenna Trainer (Product ID: 12353). Browse the full Electronics Engineering Lab Equipment range or related Electronics Lab Equipment products.

Frequently Asked Questions

What RF range does the link use?
Any frequency from 400 MHz to 3 GHz, set by the user.

Which modulation schemes are studied?
BPSK and QPSK, with I and Q channels shown in time and frequency domain.

Can bit error rate be measured?
Yes, using the internal test-data mode.

Related Categories

Electronics Engineering Lab Equipment · Electronics Lab Equipment · Engineering Lab Equipment

Request a quote: Contact Us or Tenders.

   

Office Address

Works: #975 Malleshwaram,
Bengaluru, Karnataka 560003

[email protected]

Follow Us