Home » Our Product » Electronics Engineering Lab Equipments » Integrating Differentiating and Clamping Circuits with power supply and multi range oscillator

Integrating Differentiating and Clamping Circuits with power supply and multi range oscillator Manufacturer,Supplier and Exporter in India

Product Code : SCL-EELE-12168

Indian Lab Suppliers supplies the Integrating Differentiating and Clamping Circuits with power supply and multi range oscillator (Product ID: 12168) as part of its electronics engineering lab equipment range. It is a training board for studying R-C integrating and differentiating circuits and diode clamping circuits with a built-in square-wave source.

Quick Answer

A square-wave generator switchable to 1 kHz or 10 kHz, a 0–10 V DC, 20 mA variable supply, a diode and a rotary switch for different capacitor values are built in. Students view integrator and differentiator outputs at both frequencies for different R and C combinations, then build series and shunt clamping circuits. When RC is long compared with the period the integrator gives a triangular wave, and when it is short the differentiator gives sharp spikes at each edge. Only a 20 MHz oscilloscope is needed in addition.

Key Specifications

Parameter	Detail
Signal source	Square-wave generator, 1 kHz and 10 kHz, switch selected
DC supply	0–10 V DC, 20 mA, continuously variable
Components	Diode; rotary switch for capacitor values; resistors
Experiments	Integrator and differentiator at 1 kHz and 10 kHz; series and shunt clamping
Mains input	230 V ±10%, 50 Hz AC, with mains switch, fuse and pilot lamp
Connections	4 mm terminals; stackable spring-loaded patch cords, 0.5 m
Also required	20 MHz CRO

Where This Is Used

Used in pulse and wave-shaping practicals with the Diode Limiters (Product ID: 12153). Mains powered; switch off before rewiring. Browse the full Electronics Engineering Lab Equipment range or related Electronics Lab Equipment products.