Digital Satellite Communication System Manufacturer,Supplier and Exporter in India

Product Code : SCL-EELE-12355

Indian Lab Suppliers supplies the Digital Satellite Communication System (Product ID: 12355) as part of its electronics engineering lab equipment range. It is a two-station digital satellite link trainer that sends live audio and video over a transponder so each block of the chain can be studied.

Quick Answer

A ground-station transmitter takes audio/video as UDP streams from a 10/100 Mbps IP router, adds a CRC to each packet, HDLC-encodes and scrambles the bit stream, applies variable-rate forward error correction and PSK (BPSK or QPSK) baseband modulation, then up-converts to an RF carrier set anywhere from 400 MHz to 3 GHz. The transponder relays the signal and the receiver station down-converts, demodulates and decodes it; detachable directive dish antennas are fitted at each station, and a direct link can be used in place of the satellite path. The I and Q channels use dual 16-bit, 500 MSa/s DACs with ±13 MHz analog low-pass filters. An internal test-data mode supports bit-error-rate measurement; the carrier-to-noise experiment needs a spectrum analyser, which should be confirmed at quotation.

Key Specifications

ParameterDetail
RF band400 MHz to 3 GHz, user-configurable (transmitter, transponder, receiver)
Network interfaceIP router 10/100 Mbps; UDP streaming; Ethernet port for PC
CodingCRC per IP packet; HDLC encoding and scrambling; variable-rate FEC
ModulationPSK (BPSK, QPSK), I and Q channels
DACsDual 16-bit, 500 MSa/s
Analog LPF±13 MHz (3 dB)
RFBuilt-in up and down converters, low-noise frequency synthesiser
AntennasDetachable directive dish at each station
Test modesInternal test-data mode for BER; direct or satellite link

Where This Is Used

Used in satellite and digital communication labs to run end-to-end audio and video links, BPSK/QPSK modulation, I-Q constellation and BER experiments. Antenna work continues on the Motorised Antenna Trainer (Product ID: 12353). Browse the full Electronics Engineering Lab Equipment range or related Electronics Lab Equipment products.

Frequently Asked Questions

What RF range does the link use?
Any frequency from 400 MHz to 3 GHz, set by the user.

Which modulation schemes are studied?
BPSK and QPSK, with I and Q channels shown in time and frequency domain.

Can bit error rate be measured?
Yes, using the internal test-data mode.

Related Categories

Electronics Engineering Lab Equipment · Electronics Lab Equipment · Engineering Lab Equipment

Request a Quote

For pricing, bulk quantities or tender documentation on the Digital Satellite Communication System, reach our team via Contact Us or submit your requirement through our Tenders page.

   

Office Address

Works: #975 Malleshwaram,
Bengaluru, Karnataka 560003

[email protected]

Follow Us